St.en.n - Setting Assigned Consent Number; Pre.sw - Prescaler Setting For Number Of Input Switchings; Swtch - Number Of Input Switching Setting For Signaling - gefran 850 Installation And Instruction Manual

if the Programmer 1 and 2 function is enabled in parameter PROGR on the EN.FUN menu:
(for details, see paragraph "5.13. Setpoint programmer" on page <?>):
P.P12.1 = Select program for PROGR.1 and for PROGR.2 bit 1
P.P12.2 = Select program for PROGR.1 and for PROGR.2 bit 2
P.P12.3 = Select program for PROGR.1 and for PROGR.2 bit 3
P.SS12 = START/STOP PROGR.1 and PROGR.2 programmer time base
P.ST12 = START PROGR.1 and PROGR.2 programmer time base
P.SP12 = STOP and PROGR.1 e PROGR.2 programmer time base
P.RS12 = RESET and PROGR.1 e PROGR.2 programmer time base
P.SK12 = SKIP to end program (end cycle) PROGR.1 and PROGR.2
ST.S12 = SKIP to end step PROGR.1 and PROGR.2
ST.E12 = STEP ENABLE 1/2: input with consent function at start of PROGR.1 and PROGR.2 step
If valve model with auxiliary input present, function FUnC=VALV.P and custom linear type,
and with one output configured as V.OPEN and one configured as V.CLOS:
VALV.P = Calibrazione ingresso ausiliario

4.17.5. ST.EN.N - Setting assigned consent number

Acronym
ST.EN.N IN.DIG.1 (o IN.DIG.2 ... IN.DIG.5) ENABLE NUMBER
The parameter shows and sets the consent number assigned to the digital input identified by I.DIG.N.
The parameter appears if the parameter F.in.x = ST.EN1, ST.EN2 or ST.E12.
Unit of measurement:
Options: 1...4

4.17.6. PRE.SW - Prescaler setting for number of input switchings

Acronym
PRE.SW IN.DIG.1 (o IN.DIG.2 ... IN.DIG.5) PRESCALER FOR SWITCHING CYCLES
The parameter shows and sets the prescaler for the number of switchings of the digital input with CY.CNT function.
Unit of measurement:
Options: 1...9999

4.17.7. SWTCH - Number of input switching setting for signaling

Acronym
SWTCH IN.DIG.1 (o IN.DIG.2 ... IN.DIG.5) NUMBER OF SWITCHING CYCLES
The parameter shows and sets the number of switchings of the digital input with CY.CNT function, which if exceeded
generates the scrolling message DIGITAL INPUT SWITCH ALARM.
The function is disabled if the parameter equals "0".
Unit of measurement:
Options: 1...9999
Scrolling message
Number
Scrolling message
Number
Scrolling message
Number
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 130
Submenu Attributes
IN.DIG R W
Submenu Attributes
IN.DIG R W
Submenu Attributes
IN.DIG R W