Table of Contents
Advertisement
5.13.12. SIMPLIFIED PROGRAMMER MODE
In Simplified Programmer Mode you can only use the
PR.STP menu to configure programs. To enable this mode,
adjust the S.PROG parameter in the EN.FUN menu (after
enabling programmer mode using the PROG parameter in
the EN.FUN menu).
There may be a maximum of 12 programs each, with a
maximum of 16 steps, numbered from 1 to 16.
The FI.STP and LA.STP parameters in the PR.OPT menu
disappear, as the first step in the selected program will
always be number 1. In the PR.STP menu you may indicate
which of the 16 steps will be the last step in the program
using the ST.END parameter.
The scrolling string reminds you which of the 12 programs
you are editing.
WARNING:
when
parameter in the EN.FUN menu from ON to
OFF, you must obligatorily reset the FI.STP and
LA.STP parameters in all programs, as they are
not compatible with non-simplified mode
In both simplified and non-simplified mode, the GF_eXpress
tool may be used for easy program set-up.
In non-simplified mode, the FI.STP and LA.STP parameters
appear and may be freely set:
switching
the
S.PROG
80209C_MHW_850-1650-1850_01-2020_ENG_pag. 218
In simplified mode, the FI.STP and LA.STP parameters
disappear and the ST.END parameter appears for selecting
the last step in the programi:
Advertisement
Table of Contents
