Setting Up Quick Configuration; Setting Up The Alarm - gefran 850 Installation And Instruction Manual

3.4.

Setting up quick configuration

The quick configuration menu lets you quickly configure and start a controller.
To do this, it uses default values for many of the parameters assigned to the functions and other parameters are
not activated.
With this configuration, the controller can satisfy the majority of operating requirements.
You can set up the first configuration with the main configuration menu (see paragraph "4.1 Programming/Configuration
Menu" on page 51), which gives access to all of the parameters.
For purposes of example, some of the controller's main functions are listed below, with a list of parameters to be changed
after running fast configuration to adapt the controller to specific working conditions.
3.4.1.

Setting up the Alarm

If at least one output was configured as Alarm in the fast configuration.
0000
Home page
0000
Press > 2 seconds
0
Enter password (default = 1) with the
PASS1
Press 3 times (if the model does not have remote setpoint input and current
transformer options and is not the Programmer)
ALARM
Submenu
ALARM
ALRM.N
di.in
Ab.rE
HYSTE
MSG.AL
0000
Home page
0000
and
Select the Alarm number (default = 1) with the
Description of parameter and list of options on page. 137
Press twice
Set the alarm as direct or inverse (default = Direct) with the
Description of parameter and list of options on page.90
Set the alarm as absolute or deviation (default = Absolute) with the
Description of parameter and list of options on page. 90
Press 4 times
Set hysteresis (default = -1) with the
Description of parameter and list of options on page. 92
Press twice
Select the message assigned to the alarm (default = 0) with the
Description of parameter and list of options on page. 92
Press > 2 seconds
80209C_MHW_850-1650-1850_20-2020_ENG_pag. 49
and keys
and
and keys
keys
and keys
and keys