C.hig - Setting Analog Output Maximum; Pasc0 - Setting Level Password 0; Pasc1 - Setting Level 1 Password; Pasc2 - Setting Level 2 Password - gefran 850 Installation And Instruction Manual

4.31.15. C.HIG - Setting analog output maximum

Acronym
C.HIG
The parameter shows and sets the maximum analog output value.
You can change the displayed value with the
To check the real voltage/current value on the output during calibration, measure it with a voltmeter/ammeter.
Unit of measurement:
Options: 0...65535

4.32. PASC0 - Setting level password 0

Acronym
PASC0 SET PASS0
This parameter may be used to set the password to access User Menu parameters.
Default code: 10.
Unit of measurement:
Options: 0...9999

4.33. PASC1 - Setting level 1 password

Acronym
PASC1 SET PASS1
This parameter may be used to set the password to access the level 1 configuration submenu and User Menu
parameters.
Default code: 1.
Unit of measurement:
Options: 0...9999

4.34. PASC2 - Setting level 2 password

Acronym
PASC2 SET PASS2
The parameter lets you set the password for accessing level 2 configuration submenus.
Default code: 2.
Unit of measurement:
Options: 0...9999
4.35. FI.CFG - Entering the reset code
Acronym
FI.CFG ENTER DEFAULT CONFIGURATION PASS
The parameter lets you set the code for resetting the controller to factory configuration, which will delete all changes
made.
Default code: 99.
ATTENTION! After you have set code 99, when you press the
described in paragraph "3.2. Sequence at power-on." on page <?>.
Unit of measurement:
Options: 0...9999
Scrolling message
and
Converter points
Scrolling message
Number
Scrolling message
Number
Scrolling message
Number
Scrolling message
Number
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 192
keys.
key the controller runs the Power-on procedure, as
Submenu Attributes
US.CAL R W
Password Attributes
Level 2 R W
Password Attributes
Level 2 R W
Password Attributes
Level 2 R W
Password Attributes
Level 2 R W