Time.n - Selecting Timer; Func - Selecting Timer Function Mode; St.st - Selecting The Start/Stop Timer Command; Defining The Start/Stop Timer Command Logic - gefran 850 Installation And Instruction Manual

4.23.2. TIME.N - Selecting timer

Acronym
TIME.N TIMER NUMBER
The parameter shows and sets the identifying number of the timer to be configured.
Unit of measurement:
Options: 1...2

4.23.3. FUNC - Selecting Timer function mode

Acronym
FunC TIMER.1 (o TIMER.2) TIMER FUNCTION
The parameter shows and sets the timer function mode.
The Timer function is explained in detail in paragraph "5.11. Timer" on page <?>.
Unit of measurement:
Options: ST.STP = Start/Stop Timer
STABL = Stabilization Timer
SWITC = Power-on Timer

4.23.4. ST.ST - Selecting the Start/Stop timer command

Acronym
St.St TIMER.1 (o TIMER.2) TIMER START STOP
The parameter shows and sets the "object" that commands timer Start/Stop and stabilization.
Unit of measurement:
Options: IN.DIG = From digital input
ALRM1 = From alarm 1
ALRM2 = From alarm 2
ALRM3 = From alarm 3
ALRM4 = From alarm 4
AL.HB
SERIA
4.23.5. S.S.T - Defining the Start/Stop timer command logic
Acronym
S.S.t TIMER.1 (o TIMER.2) LOGIC TYPE OF TIMER START/STOP
The parameter shows and sets the type of logic used to command timer Start/Stop.
With positive logic, timer start corresponds to "object" active if IN.DIG input active.
With negative logic, timer start corresponds to "object" inactive if IN.DIG input inactive.
Unit of measurement:
Options: POSIT
NEGAT = Negative logic
Scrolling message
Number
Scrolling message
-
Scrolling message
-
= From alarm HB
= From serial
Scrolling message
-
= Positive logic
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 157
Submenu Attributes
TIMER R W
Submenu Attributes
TIMER R W
Submenu Attributes
TIMER R W
Submenu Attributes
TIMER R W