Enrg.n - Selecting Energy Counter; Energ - Selecting The Output For Energy Calculation; V.line - Nominal Line Voltage; P.load - Nominal Power Of Load - gefran 850 Installation And Instruction Manual

4.24.2. ENRG.N - Selecting energy counter

Acronym
ENRG.N ENERGY COUNTER NUMBER
The parameter shows and sets the identifying number of the energy counter to be configured.
Unit of measurement:
Options: 1...2

4.24.3. ENERG - Selecting the output for energy calculation

Acronym
ENERG ENERG.1 (o ENERG.2) ENERGY COUNTER ENABLE
The parameter shows and sets the output to be used for the energy calculation.
The controller totalizes the time during which the output is active and uses it for the energy calculation.
Unit of measurement:
Options: OUt1
OUt2
OUt3
OUt4

4.24.4. V.LINE - Nominal line voltage

Acronym
V.LINE ENERG.1 (o ENERG.2) NOMINAL VOLTAGE
The parameter shows and sets the nominal line voltage to be used for the energy calculation.
Unit of measurement:
Options: 0...999

4.24.5. P.LOAD - Nominal power of load

Acronym
P.LOAD ENERG.1 (o ENERG.2) LOAD NOMINAL POWER
The parameter shows and sets the nominal power of the load controlled by the output.
If the parameter is set to "0.00" the data used is the RMS current measured with the CT1 or CT1 + CT2 current transfor-
mer (optional).
Unit of measurement:
Options: 0.00...99.99

4.24.6. E.COST - Nominal cost per kWh

Acronym
E.COST ENERG.1 (o ENERG.2) ENERGY COST / KWH
The parameter shows and sets the nominal cost of energy per kWh.
Unit of measurement:
Options: 0.000...9.999
Scrolling message
Number
Scrolling message
-
= Output 1
= Output 2
= Output 3
= Output 4
Scrolling message
V
Scrolling message
kW
Scrolling message
Number
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 162
Submenu Attributes
ENERG R W
Submenu Attributes
ENERG R W
Submenu Attributes
ENERG R W
Submenu Attributes
ENERG R W
Submenu Attributes
ENERG R W