Submenu Lnr.4.P - Permits Configuration Of Custom Linearisation 4 Points; Lnr.4.N - Selection Of Custom Linearisation; Md.4P - Four Point Linearisation Method - gefran 850 Installation And Instruction Manual

4.29. Submenu LNR.4.P - Permits configuration of custom linearisation 4 points

Messaggio
Acronimo
a scorrimento
LNR.4.P CUSTOM 4 POINT
LINEARIZATION
NUMBER

4.29.1. LNR.4.N - Selection of custom linearisation

Acronym
LNR.4.N CUSTOM 4 POINT LINEARIZATION NUMBER
The parameter shows and sets the identify Number of custom linearisation to configure.
Unit of measurement:
Options: 1...3

4.29.2. Md.4P - Four point linearisation method

Acronym
Md.4P (LIN.4.P.1 (0 LIN.4-P.2 o LIN.4-P.3) CUSTOM 4 POINT LINEARIZATION MODE
The parameter allows you to set the insertion mode of the linearization points.
Unit of measurement:
Options: RD.ADJ = manual point entry mode (redirects to paragraph 5.4. "Correction of four-point input" on page xxx)
CALIB = point entry method via calibrator reading (redirects to paragraph 5.4. "Correction of four-point
Password
d'accesso
Level 2
LNR.4.N
Md.4P
X1
Y1
X2
Y2
Scrolling message
Number
Scrolling message
-
input" on page xxx)
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 183
Permits configuration of custom linearisation parameters to
4 points.
The submenu is visible only if custom linearisation has been
enabled in the configuration of the main input, the auxiliary
input or the third input.
Parameter
Selection of custom
linearisation mode
Selection of
linearisation mode
X coordinate of first point
Y coordinate of first point
X coordinate of second point
Y coordinate of second point
Descrizione
Pag.
186
186
187
187
187
187
Submenu
LIN.4.P
Submenu
LIN.4.P
Attributes
R W
Attributes
RW