Mast.n - Setting The Master Communication Parameter Number; Cy.tim - Output Cycle Time; Lo.scl - Scale Minimum; Hi.scl - Scale Maximum - gefran 850 Installation And Instruction Manual

4.19.6. MAST.N - Setting the Master communication parameter number

Acronym
MAST.N OUT.AN.1 (o OUT.AN.2) MASTER PARAMETER NUMBER
This parameter shows and sets the Master parameter number associated with the output.
This parameter only appears if the F.ou.C parameter = MASTER.
Unit of measurement:
Options: 1...20
4.19.7. CY.TIM – Output cycle time
Acronym
CY.TIM OUT.AN.1 (o OUT.AN.2) CYCLE TIME
This parameter shows and sets the output partialisation period.
The parameter will appear if the StAt parameter = DI.PWM, IN.PWM.
Partialisation period is the cycle time, that is, the sum of ON time and OFF time proportional to the value to be retransmit-
ted.
Example
If the value to be retransmitted is 25% and the duration of the cycle is 10.0 seconds, the output will be active for 2.5
seconds and deactivated for 7.5 seconds.
Unit of measurement:
Options: 1...200

4.19.8. LO.SCL - Scale minimum

Acronym
LO.SCL OUT.AN.1 (o OUT.AN.2) LOW LIMIT ANALOG OUTPUT
The parameter shows and sets the scale minimum, which corresponds to minimum output value in voltage or current.
Each time you set the power control output on parameter FuNC, the parameter value is forced to 0.
The scale limit is ignored if the output is assigned to an MFB output (or calculated directly by an MFB.
Unit of measurement:
Options: -1999...9999

4.19.9. HI.SCL - Scale maximum

Acronym
HI.SCL OUT.AN.1 (o OUT.AN.2) HIGH LIMIT ANALOG OUTPUT
The parameter shows and sets the scale maximum, which corresponds to minimum output value in voltage or current.
Each time you set the power control output on parameter FuNC, the parameter value is forced to 1000.
The scale limit is ignored if the output is assigned to an MFB output (or calculated directly by an MFB).
Unit of measurement:
Options: -1999...9999
Scrolling message
Number
Scrolling message
Seconds
Scrolling message
Scale points of quantity assigned to analog output.
Scrolling message
Scale points of quantity assigned to analog output.
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 143
Submenu Attributes
OUT.AN R W
Submenu Attributes
OUT.AN R W
Submenu Attributes
OUT.AN R W
Submenu Attributes
OUT.AN R W