Pr.opt - Selecting Program; Fi.stp - Number Of First Step Assigned To Program; La.stp - Number Of Last Step Assigned To Program; Strt - Restart Mode - gefran 650 Abbreviated Manual

4. CONFIGURATION
4.5.1.

PR.OPT - Selecting program

Acronym
PR.OPT PROGRAM NUMBER
The parameter lets you select the program to be configured. During normal functioning, the controller shows the number
of the program running and its state P.STAT, viewable in the User Configuration menu.
Unit of measurement:
Options:
4.5.2.

FI.STP - Number of first step assigned to program

Acronym
FI.STP FIRST STEP OF PROGRAM
The parameter lets you select the first step of the program.
Unit of measurement:
Options:
4.5.3.

LA.STP - Number of last step assigned to program

Acronym
LA.STP LAST STEP OF PROGRAM
The parameter lets you select the last step of the program.
ATTENTION: LA.STP cannot be less than FI.STP.
Unit of measurement:
Options:
4.5.4.

Strt - Restart mode

Acronym
Strt RESTART TYPE AFTER POWER-ON
The parameter defines program restart mode after Power-on.
Unit of measurement:
Options:
4.5.5.

RST.SP - Type of control after program restart

Acronym
RST.SP CONTROL TYPE AFTER RESET
The parameter defines the type of control that the controller runs after a reset while waiting for restart.
With RST.SP = On the setpoint takes the value of PV with reset command active.
Unit of measurement:
Options:
54
40524-04 Rev0
Gefran 650/1250/1350 Temperature Controller – Abbreviated Manual
Scrolling message
Number
1...4
Scrolling message
Number
1...12
Scrolling message
Number
1...12
Scrolling message
-
FI.STP = Program restarts from first step, with setpoint attributed or equal to PV based on the
following parameter RST.SP
ST.STP = Program restarts from condition in which it stopped (last step in execution, setpoint
RSRCH = Program restarts with search for step (see programmer function...).
Scrolling message
-
OFF = The controller continues the control, maintaining the active setpoint
On
= The setpoint assumes the value of the process variable (PV) by imposing the control
output to zero.
Submenu Attributes
PR.OPT R W
Submenu Attributes
PR.OPT R W
Submenu Attributes
PR.OPT R W
Submenu Attributes
PR.OPT R W
Submenu Attributes
PR.OPT R W