Table of Contents
Advertisement
4.9.5.
LIN - Selecting linearization type
Acronym
Lin
INPUT.1 (or INPUT.2 or INPUT.3) CUSTOM LINEARIZATION
The parameter sets linearization for the selected sensor type.
The function corrects any linearity and proportionality errors in the correlation between the value sent by the input and
the actual value of the physical quantity measured..
This correction can be made with two different algorithms: 32-step linearization and 4-point linearization. Values are set (33 for 32-step
linearization and 4 for 4-point linearization) with the LINRZ submenu parameters.Z and LIN.4.P. submenu .
For an explanation of 4-point linearization, see paragraph "5.4. 4-point input correction" on page <?>.
Unit of measurement:
Options:
NONE
32.STP = 32-step linearization
4.POIN = 4-point linearization
4.9.6.
UNIT - Selecting the displayed unit of measurement
Acronym
Unit
INPUT.1 (or INPUT.2 or INPUT.3) UNIT OF MEASURE
The parameter shows and sets the unit of measurement displayed for input in use. The unit appears on the Home.x page
of the display.
For thermocouple or resistance thermometer inputs, the °C / °F selection automatically converts the temperature value;
the related scale limits and setpoint limits must be set.
Unit of measurement:
Options:
NONE
°C
°F
CUST
4.9.7.
FILT - Digital filter
Acronym
FILT
INPUT.1 (or INPUT.2 DIGITAL FILTER
The parameter shows and sets the value of the digital filter time constant.
With 0.00 no filter is applied.
Unit of measurement:
Options:
0.00...20.00
Scrolling message
T
ideal
correlation
-
= No linearization
Scrolling message
-
= No unit of measurement
= Degrees Celsius
= Degrees Fahrenheit
= Custom, settable with GF_eXpress
Scrolling message
Seconds
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 91
correlation of
input
V
Submenu
Attributes
INPUT
R W
Submenu
Attributes
INPUT
R W
Submenu
Attributes
INPUT
R W
Advertisement
Table of Contents
