Table of Contents
Advertisement
7.6.
Configuration (User menu)
Every operator has a freely accessible menu (no password
required) on which he can configure some controller
parameters.
The User Configuration menu can be built according to need
with the GF_express software, grouping up to 100 parameters
from those available for controller configuration (see chapter
"4. Configuration" on page "4. CONFIGURATION" on page
<?>).
The parameters that may be selected to build the user set-up
menu include PASS0 and PASS1; it may be useful to submit
a password to the parameters of the user menu.
Description
Local setpoint 1
SETP1
Alarm 1 limit
ALRM1
Alarm 2 limit
ALRM2
Alarm 3 limit
ALRM3
Alarm 4 limit
ALRM4
Reset alarms latch and
LBA alarm
AL.ACK
Reset scrolling message
MS.ACK
Control output value 1
OUT.P1
Visualizzazione Home
Unit of misura
scale points
scale points
scale points
scale points
scale points
80209C_MHW_850-1650-1850_01-2020_ITA_pag. 259
The controller leaves the factory with a preconfigured user
configuration menu (shown below for models:
850-x-xxx-00000-x-xxx and 1650-x-xxx-00000-x-xxx).
This menu can subsequently be modified. The related
parameters are shown for models with options; the complete
list of parameters is shown on the GF_eXpress user menu
page.
Press the
key to access the User Configuration menu.
GF_eXpress can be used to set the generic user menu
parameter to set automatic back to PV\Home when
positioned on the parameter and no key is pressed within
15 seconds.
Valid values
LO.SP1...HI.SP1
If absolute alarm.
LO.AL1...HI.AL1
-999...999
If deviation alarm.
If absolute alarm.
LO.AL1...HI.AL1
-999...999
If deviation alarm.
If absolute alarm.
LO.AL1...HI.AL1
-999...999
If deviation alarm.
If absolute alarm.
LO.AL1...HI.AL1
-999...999
If deviation alarm.
Appears if at least one alarm with
latch was set or if LBA alarm was
Off
On
enabled.
rary and is not saved.
Appears if a scrolling message is present.
Off
The reset command is temporary and is
On
not saved.
-100.0...100.0
Value Read Only
On / OFF
Notes
The reset command is tempo-
Advertisement
Table of Contents
