Led.1 - Enable Run Led Flashing - gefran 850 Installation And Instruction Manual

if ENERG function enabled and model with CT1+CT2:
CURR
if the ENERG function is enabled:
OUT.KW = Power on load
if the Timer function is enabled:
TIM.RE = Remaining timer value
TIM.EL = Timer value elapsed
if controller model with valve control:
V.POSI = Valve position
if the Programmer function is enabled in parameter PROGR on the EN.FUN menu:
P.TIME = Current step time (ramp or hold)
P.T.TIM = Program total theoretical time
P.R.TIM = Program total theoretical residual time
IN1
if model with auxiliar input 2
IN3
if model with Modbus Master serial and Master parameter configured:
MAS.01 = Master value 1
MAS.02 = Master value 2
MAS.03 = Master value 3
MAS.04 = Master value 4
MAS.05 = Master value 5
MAS.06 = Master value 6
MAS.07 = Master value 7
MAS.08 = Master value 8
MAS.09 = Master value 9
MAS.10 = Master value 10
MAS.11 = Master value 11
MAS.12 = Master value 12
MAS.13 = Master value 13
MAS.14 = Master value 14
MAS.15 = Master value 15
MAS.16 = Master value 16
MAS.17 = Master value 17
MAS.18 = Master value 18
MAS.19 = Master value 19
MAS.20 = Master value 20

4.28.10. LED.1 - Enable RUN led flashing

Acronym
LED.1 ENABLE OF RUN LED BLINKING
The parameter enables and disabled RUN led flashing
Unit of measurement:
Options: OFF
On
= Load current (on 1850 LED A on)
= Main input
= Auxiliar input 2
Scrolling message
-
= Disables RUN led flashing
= Enables RUN led flashing
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 181
Submenu Attributes
HOME R W