Functional Diagram; Ou.an.n - Selecting The Output; Stat - Defining The State Of The Analog Output - gefran 850 Installation And Instruction Manual

4.19.1. Functional diagram

NONE
HEAT1/HEAT2
COOL1/COOL2
H+C1/H+C2
IN1/IN2/IN3
PV1/PV2
SSP1/SSP2
SETP1/SETP2
DEVI1/DEVI2
SLV.S1/SLV.S2
SERIA
MASTER

4.19.2. OU.AN.N - Selecting the output

Acronym
OU.AN.N ANALOG OUTPUT NUMBER
The parameter shows and sets the identifying number of the output to be configured.
Unit of measurement:
Options: 1...2

4.19.3. STAT - Defining the state of the analog output

Acronym
StAt OUT.AN.1 (o OUT.AN.2) ANALOG OUTPUT STATUS
The parameter shows and sets the state of analog retransmission output A1 or A2.
The active direct output corresponds to minimum with the minimum output value in voltage or current.
The active inverse output corresponds to minimum with the maximum output value in voltage or current.
The outputs can be forced so that they are always on or off.
Unit of measurement:
Options: DIREC = Direct output
INVRS
OFF
ON
DI.PWM = Direct output with partialisation of ON/OFF and cycle time CY.TIM
IN.PWM = Inverse output with partialisation of ON/OFF and cycle time CY.TIM
Function
FUNC pag.
142
OFF
ON
CY.TIM
GESTIONE PWM
with analog levels
Probe type
TYPE pag. 142
Scrolling message
Number
Scrolling message
-
= Inverse output
= Forced output inactive (minimum voltage or current value)
= Forced output active (maximum voltage or current value)
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 141
Definition
state
STAT page 141
Scale limit
LO.SCL page 143
HI.SCL page 143
Analog output
state
OUT.Ax page
Analog output
Submenu Attributes
OUT.AN R W
Submenu Attributes
OUT.AN R W