Table of Contents
Advertisement
4.15. Submenu PID.GR - Configuring groups of control parameters
Acronym
Scrolling message
PID.GR
PID GROUP
PARAMETERS CONFIG
PID.G.N
Password
Level 1
Parameter
Selecting the parameter
PID.N
group to be configured
Selecting the parameter
group to be configured
Proportional heating
band or hysteresis in
H.PB
ON-OFF control
Integral heating time
H.IT
Derivative heating time 123
H.DT
Maximum limit of
H.P.HI
heating power
Minimum limit of
H.P.LO
heating power
Proportional cooling
band or hysteresis in
C.PB
ON-OFF control
Integral cooling time
C.IT
Derivative cooling time 124
C.DT
Maximum limit of
C.P.HI
cooling power
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 122
Lets you configure groups of control parameters. Groups of
control parameters must be enabled with the parameter PID.
GN = .1...4 on the MODE menu (the menu is not shown if PID.
GN = 0).
Groups are used to preconfigure sets of function parameters
that can be easily called when needed, without having to re-
configure the PID parameters every time. The number of pa-
rameters available in groups is less than the number on the
PID submenu. The number of parameters available in groups
is limited to those for PID heating and/or cooling control.
Pag.
Parameter
Minimum limit of
123
C.P.LO
cooling power
Threshold PV for the
123
PV.THR
activation of the group
of PID parameters
123
123
74
124
124
124
<?>
Description
Pag.
125
125
Advertisement
Table of Contents
