Wait.s - Option To Start Execution Of Program; End - Action At End Of Program; Limit - Limitation Of Step Duration; Pr.stp Submenu - Configuration Of Program Steps - gefran 650 Abbreviated Manual

4.5.6.

WAIT.S - Option to start execution of program

Acronym
WAIT.S DEF OF START EXEC PROGRAM
Il parametro abilita o disabilita l'esecuzione automatica del reset della base tempi del programma dopo una commutazio-
ne STOP/START.
Unit of measurement:
Options:
4.5.7.

End - Action at end of program

Acronym
End CONDITION AT END OF CYCLE
The parameter defines what happens when the program in execution ends (last step done).
Unit of measurement:
Options:
4.5.8.

LIMIT - Limitation of step duration

Acronym
LIMIT DEF OF STEP TIMING LIMITATION
The parameter enables or disables limitation of step duration. It is useful for quick execution of the program.
Eventuale HBB è disabilitato e l'uscita di controllo è forzate al valore di FAULT.
Unit of measurement:
Options:
4.6.

PR.STP Submenu - Configuration of program steps

Acronym
PR.STP
40524-04 Rev0
Gefran 650/1250/1350 Temperature Controller – Abbreviated Manual
Scrolling message
-
OFF
= Disables automatic execution
On
= Enables automatic execution
Scrolling message
-
NONE = Nothing happens. The controller continues control
rESE = switching in the RESET state, the control type will depend on the parameter RST.SP
LOOP
= The program restarts from the first step
OFF
= The program ends and puts the controller in the OFF position, with control output to zero
Scrolling message
-
OFF = Disables limitation of step duration
On = Enables limitation of step duration: limits ramp times to 20 seconds and hold times to 10
seconds, in order to have a step time that never exceeds 30 seconds.
Scrolling message Password
STEP DEFINITION Level 1 Lets you configure the steps that make up the program.
The parameters are configured for each step to be used.
The Programmer function must first be enabled with the
MODE menu, parameter PROGR = On.
For more information on configuring the programmer, see
paragraph "5.13. Set point programmer" page 149.
4. CONFIGURATION
Submenu Attributes
PR.OPT
Submenu Attributes
PR.OPT
Submenu Attributes
PR.OPT
Description
R W
R W
R W
55