4. CONFIGURATION
The parameter shows and sets enabling of the setpoint programmer for P or PV models.
Unit of measurement:
Options:
4.19.15. t.Pro - Setting the programmer base time
Acronym
t.Pro
PROGRAMMER BASE TIME DEFINITION
The parameter shows and sets the base time used by the programmer.
The parameter appears if the parameter PROGR = On.
Unit of measurement:
Options:
4.19.16. ENERG - Enabling the energy counter function
Acronym
ENERG
ENERGY COUNTER ENABLE
The parameter shows and sets enabling of the energy counter function.
The Energy Counter function is explained in detail in paragraph "5.15. Energy Counter" on page 154.
Unit of measurement:
Options:
4.19.17. T.SAMP - Main input sample time
Acronym
T.SAMP
MAIN INPUT SAMPLE TIME
The parameter shows and sets the main input sample time.
Unit of measurement:
Options:
4.19.18. FREQZ - Defining power line frequency
Acronym
FREQZ
LINE FREQUENCY
The parameter shows and sets the power line frequency
Unit of measurement:
Options:
114
40524-04 Rev0
Gefran 650/1250/1350 Temperature Controller – Abbreviated Manual
-
OFF
= Setpoint programmer disabled
On
= Setpoint programmer enabled
Scrolling message
-
HH.MM = Base time calculated in hours:minutes
MM.SS = Base time calculated in minutes:seconds
Scrolling message
-
OFF
= Energy counter disabled
On
= Energy counter enabled
Scrolling message
Milliseconds
60
120
Scrolling message
Hz
50
60
Submenu
Attributes
MODE
R W
Submenu
Attributes
MODE
R W
Submenu
Attributes
MODE
R W
Submenu
Attributes
MODE
R W