F.tim - Selecting Timer Function Mode; St.st - Selecting The Start/Stop Timer Command; Defining The Start/Stop Timer Command Logic; Rese - Selecting The Reset Timer Command - gefran 650 Abbreviated Manual

4. CONFIGURATION

4.20.1. F.tiM - Selecting Timer function mode

Acronym
F.tiM TIMER FUNCTION
The parameter shows and sets the timer function mode.
The Timer function is explained in detail in paragraph "5.11. Timer" on page 147.
Unit of measurement:
Options:

4.20.2. St.St - Selecting the Start/Stop timer command

Acronym
St.St TIMER START STOP
The parameter shows and sets the "object" that commands timer Start/Stop.
Unit of measurement:
Options:
4.20.3. S.S.t - Defining the Start/Stop timer command logic
Acronym
S.S.t LOGIC TYPE OF TIMER START/STOP
The parameter shows and sets the type of logic used to command timer Start/Stop.
With positive logic, timer start corresponds to "object" active if IN.DIG input active.
With negative logic, timer start corresponds to "object" inactive if IN.DIG input inactive.
Unit of measurement:
Options:

4.20.4. rESE - Selecting the Reset timer command

Acronym
rESE TIMER RESET
The parameter shows and sets the "object" that commands Reset of the timer.
Unit of measurement:
Options:
116
40524-04 Rev0
Gefran 650/1250/1350 Temperature Controller – Abbreviated Manual
Scrolling message
-
ST.STP = Start/Stop Timer
STABL = Stabilization Timer
SWITC = Power-on Timer
Scrolling message
-
IN.DIG = From digital input
ALRM1 = From alarm 1
ALRM2 = From alarm 2
ALRM3 = From alarm 3
ALRM4 = From alarm 4
AL.HB = From HB alarm
SERIA = From serial
Scrolling message
-
POSIT = Positive logic
NEGAT = Negative logic
Scrolling message
-
AUT.RS = For autoreset with timer in Stop
IN.DIG = From digital input with T.RST function
ALRM1 = From alarm 1
ALRM2 = From alarm 2
ALRM3 = From alarm 3
ALRM4 = From alarm 4
AL.HB = From HB alarm
SERIA = From serial
Submenu Attributes
TIMER R W
Submenu Attributes
TIMER R W
Submenu Attributes
TIMER R W
Submenu Attributes
TIMER R W