Table of Contents
Advertisement
b. Set the Loop option to ON by pressing
4. Open and close the tape library.
This action causes the tape library to inventory cartridge locations and place a tape
cartridge in each tape drive.
5. Press Escape until you get to the Primary Menu.
6. Select the Main Screen by pressing Enter.
Leave the tape library in Main Screen mode for normal operation.
7. Start the SunDiag system exerciser.
7.2.2
25-pin, 9-pin, and 4-pin Serial Port Modes
The 25-pin, 9-pin and 4-pin serial port modes are not supported on Sun systems.
7.3
Configuration Menu
The Configuration Menu consists of the following submenus:
Set SCSI IDs
Set SCSI parity checking
Sequential options
Adjust contrast
Backlight
Set date
Set time
Set security
Set serial number
Use Mammoth
7.3.1
Set SCSI IDs
The tape library is configured with default SCSI IDs for the CHM and for each tape
drive. This section describes how to view the default settings and change them, if
necessary. SCSI IDs can be viewed and changed from the Operator Panel
(FIGURE 6-1).
7-6
Sun StorEdge L400 Installation and User's Guide • April 1998
←
→
or
.
Advertisement
Table of Contents
