Activating And Licensing Technology Functions - Siemens SINUMERIK 840Di sl Commissioning Manual

NC Commissioning with HMI Advanced
11.8 Loadable compile cycles
System enables
If the compile cycle is not enabled in conjunction with SINUMERIK 840Di sl or 840DiE sl, the
following alarm is issued:
Not enabled for SINUMERIK 840Di sl:
● Alarm "7200 CC<Identifier>_ELF NO_840Di"
Not enabled for SINUMERIK 840DiE sl:
● Alarm "7200 CC<Identifier>_ELF NO_EMBARGO"
11.8.5

Activating and licensing technology functions

Activating and licensing the option
To activate the technological function loaded onto the NC by means of the compile cycle, the
respective option must be set and licensed.
For information about how to activate and license options, please see Chapter "License
Management" (Page 146).
Activating the technological function
Each loaded compile cycle generates a technological function-specific global machine data:
● $MN_CC_ACTIVE_IN_CHAN_<
in the machine data number range 60900 to 60999.
You can activate the entire technological function in the individual channels or individual
subfunctions via the general NC machine date mentioned above.
For a description of the machine data, please see Chapter "Data Descriptions
(MD)" (Page 483).
References:
The individual technological functions are described in:
/FB3/ Function Manual - Special Functions, Chapters TE1 to TE8
482
CAUTION
If alarm "7200 . . . " is present after an NC startup, none of the loaded compile cycles is
active.
identifier
>[n], with n = 0, 1
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Manual