Creating A Profibus Configuration; Requirement - Siemens SINUMERIK 840Di sl Commissioning Manual

8.3

Creating a PROFIBUS configuration

8.3.1

Requirement

S7 project
The procedure described in this Section for setting up the PROFIBUS configuration as well
as the parameterization of various components (for example, SINAMIC drives, ADI4), is
based on an S7 project created using the description in Chapter "Create PROFIBUS
Configuration"
The following status of the S7 project is required:
● S7 project is has been set up (name: SIN840Di sl)
● Station 300 has been set up
● Interface (X102) PROFIBUS is parameterized (optional)
● Interface (X101) PROFIBUS is parameterized
● Input/output data areas of the NC are parameterized
Starting HW Config
Start "HW Config" by opening the station and double-clicking the hardware icon.
Figure 8-4
In HW Config, now insert the required PROFIBUS modules from the hardware catalog into
the S7 project.
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Note
The instructions given in this Section are essentially limited to the special characteristics
of the SINUMERIK 840Di sl. For more details about working with SIMATIC STEP 7
please refer to the relevant SIMATIC documentation or online help.
Inserting the SIMATIC 300 station
PROFIBUS DP Communication
8.3 Creating a PROFIBUS configuration
239