8.11
DP slave diagnostic repeater for PROFIBUS DP
8.11.1
Function
Figure 8-24
A diagnostic repeater can monitor the segment of an RS 485 PROFIBUS subnet (copper
cable) during normal operation and report line faults in a diagnostic message frame to the
DP master. Used together with the SINUMERIK 840Di sl it is possible to display the location
and cause of the fault in plaintext via SIMATIC STEP 7.
Tasks
The diagnostic repeater primarily performs the following tasks:
● Diagnostic function for two PROFIBUS segments (DP2 and DP3):
● Repeater function for three PROFIBUS segments (DP1, DP2, DP3):
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Example: PROFIBUS topology with diagnostic repeater
The diagnostic function supplies the location and causes of cable breakage such as line
faults or missing terminating resistors.
The Diagnostics Repeater amplifies the data signals on the bus cables and connects
individual RS 485 segments.
PROFIBUS DP Communication
8.11 DP slave diagnostic repeater for PROFIBUS DP
305