Drives: Simodrive; Nc/Plc Interface Signals - Siemens SINUMERIK 840Di sl Commissioning Manual

Axis and Spindle Test Run
13.1 Requirements
13.1.2

Drives: SIMODRIVE

Relevant terminals
Applies to the following SIMODRIVE drives:
● SIMODRIVE 611 universal/universal E
● SIMODRIVE POSMO SI, CD/CA
The following terminals must be connected:
I/RF module
Drive Module
Signal TRUE: +24 V (e.g. from terminal 9)
References:
/FBU/ Function Manual SIMODRIVE 611 universal
/POS3/ User Manual - SIMODRIVE SI/CD/CA
13.1.3

NC/PLC interface signals

Relevant NC/PLC interface signals
The following NC/PLC interface signals must be set:
DB number
31, ...
31, ...
31, ...
31, ...
31, ...
31, ...
31, ...
31, ...
31, ...
31, ...
31, ...
31, ...
502
Terminal Description
63 Pulse enable
64 Drive enable
48 DC-link start
Terminal Description
663 Pulse enable
Byte.Bit
0
1.3
1.4
1.5
1.6
1.7
2.1
2.2
4.3
4.4
4.6
4.7
Value Description
<> 0% Feedrate/spindle override
FALSE Axis/spindle disable
FALSE Follow-up mode
TRUE Position measuring system 1
TRUE Position measuring system 2
TRUE Override active
TRUE Controller enable
FALSE Distance-to-go/Spindle reset
FALSE Feed stop/spindle stop
FALSE Traversing-key lock
Traversing key -
3)
Traversing key +
3)
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
1)
1)
Manual