Siemens SINUMERIK 840Di sl Commissioning Manual page 579

Requirements
The following conditions must be fulfilled:
● HMI Basic is installed on the computer (PC/PG) on which the Automation License
● The IP addresses of the SINUMERIK control systems with which the Automation License
Procedure: Creating parameters for the first time
Perform the following actions when creating user-specific communication parameters for the
first time:
1. Create the following text file, if it does not already exist:
2. Open the file MMC.INI with a text editor.
3. Copy the [GLOBAL] section from the above-mentioned table "User-specific file: MMC.INI"
4. Copy the [AddressParameter] section from the above-mentioned table "User-specific file:
5. Replace the "AddressParameter" string by a relevant unique designation for all sections
6. Replace the IP address string by the relevant IP address of the corresponding
7. In the [GLOBAL] section, replace the "AddressParemeter" string with the section name
Procedure: Changing the active control system (online)
Perform the following actions to change the active control system (online), i.e. the
SINUMERIK control system with which the Automation License Manager communicates:
1. Close the Automation License Manager.
2. Open the file <installation drive>:\Siemens\Sinumerik\HMI-Advanced\user\MMC.INI with a
3. In the [GLOBAL] section, replace the current address string with the section name for the
4. Run Automation License Manager.
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Manager is running.
Manager must communicate are known.
<Installation drive>:\Siemens\Sinumerik\HMI-Advanced\user\MMC.INI
to the open file MMC.INI.
MMC.INI" to the open file MMC.INI according to the number of available SINUMERIK
control systems.
[AddressParameter]
SINUMERIK control system in all the sections [AddressParameter].
for the SINUMERIK control system with which the Automation License Manager should
communicate after booting. (See note "Changing the IP address" above.)
(See note "Changing the IP address" above.)
text editor.
SINUMERIK control system with which the Automation License Manager should
communicate after booting.
17.3 Assigning via Automation License Manager
License management
579