Sinumerik-Specific Applications - Siemens SINUMERIK 840Di sl Commissioning Manual

Power-On and Power-Up
5.4 Service Desktop
5.4.2

SINUMERIK-specific applications

The following SINUMERIK-specific applications are available on the Service Desktop:
● Ghost Explorer
● HMI Explorer
● Touchware
● System Network Center
● HMI Analyzer
● ServiceCenter
136
The Ghost Explorer is used to display the content of Ghost images.
References:
The Ghost tools documentation is located on the PCU hard drive under: E:\TOOLS
The HMI Explorer is used to display the version and install or post-install the supplied
SINUMERIK application. See Section "HMI Explorer" (Page 140).
Program for calibrating the touchscreen connected to the PCU directly.
References:
Equipment Manual "Operator components and Networking",
Chapter: PCU 50.3 > Commissioning > Calibration of the touchscreen
Setting up the Ethernet connection of a TCU to the SINUMERIK 840Di sl.
References:
Equipment Manual "Operator components and Networking",
Chapter: Networking > Commission system network > PCU: System Network Center
(SNC)
Analysis tool for HMI Advanced in conjunction with PCU 50.3
References:
"Base software and HMI-Advanced" Commissioning Manual
Chapter: Diagnosis and Service > HMI-Analyzer
Starts the ServiceCenter after the computer reboots under WinPE to create, restore and
manage partition and hard disk images.
References:
"Base software and HMI-Advanced" Commissioning Manual
Chapter: PCU-Basesoftware 8.x > Save and restore data
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Manual