Dp Slave Mcp 483; Conditions For General Commissioning - Siemens SINUMERIK 840Di sl Commissioning Manual

PROFIBUS DP Communication

8.7 DP slave MCP 483

8.7 DP slave MCP 483
Figure 8-16 MCP 483 front panel; Version T (turning machines)
8.7.1

Conditions for general commissioning

Hardware
The following hardware is required:
● PROFIBUS connecting cable
Software
The following software is required:
● PLC basic program
● SIMATIC STEP 7
● DP slave MCP 483
270
No terminating resistor is integrated in the machine control panel.
The relevant modules of the basic PLC program are FB 1 (MCP communication
parameters), FC 19 (interface parameter assignment version: milling) and FC 25
(interface parameter assignment, version: turning).
The library of the basic PLC program is a part of the SINUMERIK 840Di sl. The
installation of the library is described in detail in the Section "Create PLC
Program" (Page 177).
SIMATIC STEP 7 is needed to customize the PLC basic and user programs to the
requirements of the respective automation system. SIMATIC STEP 7 can be installed
directly on the PCU of the SINUMERIK 840Di sl. The installation of additional software is
described in the Section "SW Installation/Update and Data Backup" (Page 551).
The MCP 483 DP slave is an integral part of the PLC toolbox. When the PLC Toolbox is
installed, it is automatically installed in SIMATIC STEP 7.
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Manual