Siemens SINUMERIK 840Di sl Commissioning Manual page 440

NC Commissioning with HMI Advanced
11.5 Axes and spindles
Machine data
Table 11-38 Referencing: Machine data
Number Name
General ($MN_ ... )
11300 JOG_INC_MODE_LEVELTRIGGRD
Channelspecific ($MC_ ... )
20700 REFP_NC_START_LOCK
Axisspecific ($MA_ ... )
30200 NUM_ENCS
30240 ENC_TYP
30242 ENC_IS_INDEPENDENT
31122 BERO_DELAY_TIME_PLUS
31123 BERO_DELAY_TIME_MINUS
34000 REFP_CAM_IS_ACTIVE
34010 REFP_CAM_DIR_IS_MINUS
34020 REFP_VELO_SEARCH_CAM
34030 REFP_MAX_CAM_DIST
34040 REFP_VELO_SEARCH_MARKER
34050 REFP_SEARCH_MARKER_REVERSE
34060 REFP_MAX_MARKER_DIST
34070 REFP_VELO_POS
34080 REFP_MOVE_DIST
34090 REFP_MOVE_DIST_CORR
34092 REFP_CAM_SHIFT
34100 REFP_SET_POS
34102 REFP_SYNC_ENCS
34110 REFP_CYCLE_NR
34120 REFP_BERO_LOW_ACTIVE
34200 ENC_REFP_MODE
34210 ENC_REFP_STATE
34220 ENC_ABS_TURNS_MODULO
34300 ENC_REFP_MARKER_DIST
34310 ENC_MARKER_INC
34320 ENC_INVERS
34330 REFP_STOP_AT_ABS_MARKER
35150 SPIND_DES_VELO_TOL
36302 ENC_FREQ_LIMIT_LOW
36310 ENC_ZERO_MONITORING
30250 ACT_POS_ABS
440
Name
INC/REF in jog/continuous mode
NC-Start disable without reference point
Number of encoders
Actual value encoder type
Encoder is independent
BERO delay time in plus direction
BERO delay time in minus direction
Axis with reference cam
Reference point approach in minus direction
Reference point approach velocity
Maximum distance to reference cam
Reference point creep speed
Direction reversal to reference cam
Maximum distance to reference mark; Maximum distance to two
reference marks with distance-coded scales
Reference point positioning velocity
Reference point distance/destination point for distancecoded
system
Reference point/absolute offset, distancecoded
Electronic reference cam shift for incremental measurement
systems with equidistant zero marks.
Reference point value
Actual value adjustment to the referencing measurement system
Axis sequence for channel-specific Homing
Polarity change of BERO
Referencing mode
Status of absolute encoder
Absolute encoder range for rotary encoders
Reference marker distance with distancecoded scales
Interval between two reference marks with distancecoded scales
Linear measuring system inverse to machine system
Distance-coded linear measuring system without destination
destination point
Spindle speed tolerance
Encoder limit frequency resynchronization
Zero mark monitoring
Absolute encoder position at time of deactivation.
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Manual