Danfoss VLT FC 102 Programming Manual page 131

Parameter Descriptions
13-02 Stop Event
Option: Function:
[42] Auto Reset This event is true if the frequency
Trip converter is tripped (but not trip-
locked) and an automatic reset is
issued.
[43] OK Key This event is true if [OK] is pressed.
[44] Reset Key This event is true if [Reset] is
pressed.
[45] Left Key This event is true if [◄] is pressed.
[46] Right Key
This event is true if [►] is pressed.
[47] Up Key
This event is true if [
[48] Down Key
This event is true if [
[50] Comparator 4 Use the result of comparator 4 in
the logic rule.
[51] Comparator 5 Use the result of comparator 5 in
the logic rule.
[60] Logic rule 4 Use the result of logic rule 4 in the
logic rule.
[61] Logic rule 5 Use the result of logic rule 5 in the
logic rule.
[70] SL Time-out 3 Use the result of timer 3 in the
logic rule.
[71] SL Time-out 4 Use the result of timer 4 in the
logic rule.
[72] SL Time-out 5 Use the result of timer 5 in the
logic rule.
[73] SL Time-out 6 Use the result of timer 6 in the
logic rule.
[74] SL Time-out 7 Use the result of timer 7 in the
logic rule.
[76] Digital Input
x30 2
[77] Digital Input
x30 3
[78] Digital Input
x30 4
[80] No Flow
[81] Dry Pump
[82] End of Curve
[83] Broken Belt
[90] ECB Drive
Mode
[91] ECB Bypass
Mode
[92] ECB Test Mode
[93] RS Flipflop 6
[94] RS Flipflop 0
[95] RS Flipflop 1
[96] RS Flipflop 2
M0010001
Programming Guide
13-02 Stop Event
Option:
[97]
[98]
[99]
[100]
[101]
[103]
[104]
[109]
[110]
▲
] is pressed.
[111]
▼
] is pressed.
[140]
[141]
[142]
[143]
[144]
[145]
[146]
[147]
[148]
[149]
[150]
[151]
13-03 Reset SLC
Option:
[0]
*
[1]
Danfoss A/S © 10/2019 All rights reserved.
Function:
RS Flipflop 3
RS Flipflop 4
RS Flipflop 5
Fire Mode See parameter 13-15 RS-FF Operand
S and parameter 13-16 RS-FF
Operand R.
RS Flipflop 7
Relay 1
Relay 2
Relay 7
Relay 8
Relay 9
ATEX ETR cur.
warning
ATEX ETR cur.
alarm
ATEX ETR freq.
warning
ATEX ETR freq.
alarm
Pressure 1
Low
Pressure 2
Low
Pressure 3
Low
Pressure 4
Low
Pressure 1
High
Pressure 2
High
Pressure 3
High
Pressure 4
High
Function:
Do not reset Retain programmed settings in
SLC parameter group 13-** Smart Logic.
Reset SLC Reset all parameters in parameter
group 13-** Smart Logic to default
settings.
3 3
129