Danfoss VLT FC 102 Programming Manual page 121

Parameter Descriptions
8-32 Baud Rate
Baud rates 9600, 19200, 38400, and 76800 are valid for BACnet
only. The default value depends on the FC protocol.
Option: Function:
[2] 9600 Baud
[3] 19200 Baud
[4] 38400 Baud
[5] 57600 Baud
[6] 76800 Baud
[7] 115200 Baud
8-33 Parity / Stop Bits
Parity and stop bits for the protocol parameter 8-30 Protocol
using the FC port. For some of the protocols, not all options are
visible. Default depends on the protocol selected.
Option: Function:
[0] Even Parity, 1
Stop Bit
[1] Odd Parity, 1
Stop Bit
[2] No Parity, 1
Stop Bit
[3] No Parity, 2
Stop Bits
8-34 Estimated cycle time
Range: Function:
0 ms [0 - 1000000 In noisy environments, the interface
*
ms] may be blocked due to overload or
bad frames. This parameter specifies
the time between 2 consecutive
frames on the network. If the
interface does not detect valid
frames in that time, it flushes the
receive buffer.
8-35 Minimum Response Delay
Range: Function:
Size [ 5 - 10000 Specify the minimum delay time
related ms] between receiving a request and
*
transmitting a response. This is
used for overcoming modem
turnaround delays.
8-36 Maximum Response Delay
Range: Function:
Size [ 11 - 10001 Specify the maximum allowed delay
related ms] time between transmitting a
*
request and receiving a response.
Exceeding this delay time causes
control word timeout.
M0010001
Programming Guide
8-37 Maximum Inter-Char Delay
Range:
Size
related
*
8-39 Protocol Firmware version
Range:
0
*
3.9.5 8-4* Telegram Selection
8-40 Telegram Selection
Enables the use of freely configurable telegrams or standard
telegrams for the FC port.
Option:
[1]
*
[101]
[102]
[103]
[104]
[105]
[106]
[107]
[108]
[200]
8-42 PCD Write Configuration
Range:
[0]
[302]
[303]
[341]
[342]
[351]
[352]
[380]
[381]
[411]
[412]
Danfoss A/S © 10/2019 All rights reserved.
Function:
[ 0.00 - 35.00 Specify the maximum allowed time
ms] interval between receipt of 2 bytes.
This parameter activates timeout if
transmission is interrupted.
Function:
[0 - 10 ]
Function:
Standard
telegram 1
PPO 1
PPO 2
PPO 3
PPO 4
PPO 5
PPO 6
PPO 7
PPO 8
Custom
telegram 1
Function:
None
Minimum
Reference
Maximum
Reference
Ramp 1 Ramp
Up Time
Ramp 1 Ramp
Down Time
Ramp 2 Ramp
Up Time
Ramp 2 Ramp
Down Time
Jog Ramp
Time
Quick Stop
Ramp Time
Motor Speed
Low Limit
[RPM]
Motor Speed
Low Limit [Hz]
3 3
119