Removing Protective Materials - MUTOH ValueJet VJ-1604 Operation Instructions Manual

Follow the procedure below to attach the waste fluid tank.
Step 4 :
•
Place the waste fluid tank in the waste fluid holder
•
Attach the waste fluid tube to the tank
•
Attach the waste fluid sensor cable to the connector on the bottom of the printer

2.5.3 Removing protective materials

Remove the tape from each cover.
Step 1 :
Open the front cover, loosen the butterfly screw and remove the metal plate which is fixing the
Step 2 :
head unit.
Notes
•
Do not throw away this metal plate, you will need it again if you ever want to transfer or transport your
printer.
Open the left maintenance cover and place the tray.
Step 3 :
24
Operation Instructions VJ-1604
No. Name
1 Waste fluid tank holder
2 Waste fluid tank
3 Waste fluid tube
4 Waste fluid sensor cable
Waste fluid sensor
5
connector
No. Name
1 Head unit
2 Butterfly screw
Head unit fastening
3 material
(metal plate)
No. Name
1 Maintenance cover left
2 Tray
AP-75769 - Revision 1.0 –2/04/2007
English