Cleaning Around The Print Head - MUTOH ValueJet VJ-1604 Quick Reference

VJ-1604 QUICK REFERENCE
4.2.5

Cleaning around the print head

This section describes how to clean around the print head.
(1) Cleaning time
When foreign objects, such as dust or ink causing omitted dots or ink drops are attached around the print
head.
(2) Cleaning method
Follow the procedure below to clean around the print head.
NOTE NOTE
• Before starting to clean around the print head, read and understand this procedure,
then clean promptly and accurately.
• When cleaning around the print head, the print head cap must be removed and
cleaning must be complete before the head dries. The recommended time for
cleaning is about 15 minutes.
If cleaning exceeds 15 minutes, discontinue it by following steps 7 and 8. Perform
Head cleaning, and then start cleaning around the print head again.
4.2.3 Head cleaning
• Use the cleaning stick to clean around the print head.
For cleaning stick, refer to "8.3 Supply list" in the Operation Manual.
1. If the printer is turned ON, make sure the following.
• Printing or other operations are not in progress.
• The operation panel display is Normal.
2. Display the CR Maintenance menu on the operation panel.
a. Press the [Menu] key on the operation panel.
•
•
4-16
"Menu 1: Setup>" is displayed on the operation panel.
The operation panel shifts to the Setup menu display.
4 Daily maintenance