Setting The Internal Clock; Setting The Date/Time; Setting The Date/Time - Agilent Technologies ENA Series Installation And Quick Start Manual

Setting the Internal Clock

You can set the date/time displayed at the lower right of the screen. When you save data in
the storage unit, for example, the internal clock data will be used. The following describes
the setting procedure that uses keys on the front panel.
NOTE When turning on the instrument power for the first time after delivery, always be sure to set
the internal clock.

Setting the Date/Time

Step 1. Press the
focus to the
key to move the focus to the
Point the focus to the
Properties dialog box will appear (Figure 2-11).
Figure 2-11 Date/Time Properties Dialog Box ("Date & Time" Tab)
Step 2. Turn the rotary knob (
press the
Chapter 2
key in the INSTR STATE block. Press the
[System]
button and then press the
Misc Setup
Clock Setup
Set Date and Time
)on the front panel to point the focus to the
key to move the focus to the
[→]

Setting the Internal Clock

or
[↓] [↑]
or key. Press the
[Enter] [→]
button and then press the [Enter]
button and press the key. The Date/Time
[Enter]
Date & Time
tab (Figure 2-12).
Time Zone
Installation
key to move the
or
[↓] [↑]
or [→] key.
tab and
33