Parameter Selection - Danfoss VLT Decentral FCD 300 Operating Instructions Manual

VLT® Decentral FCD

3.1.9 Parameter Selection

Menu mode is started by pressing the [MENU] key, which produces the
following readout on the display:
FREQUENCY
50.0 Hz
0 KEYB.&DISPLAY
Line 3 on the display shows the parameter group number and name.
In Menu mode, the parameters are divided into groups. Selection of pa-
rameter group is effected using the [< >] keys.
The following parameter groups will be accessible:
Group no. Parameter group
0 Operation & Display
1 Load & Motor
2 References & Limits
3 Inputs & Outputs
4 Special functions
5 Serial communication
6 Technical functions
When the required parameter group has been selected, each parameter
can be chosen by means of the [+ / -] keys:
FREQUENCY
50.0 Hz
001 LANGUAGE
ENGLISH
The 3rd line of the display shows the parameter number and name, while
the status/value of the selected parameter is shown in line 4.
Changing data
Regardless of whether a parameter has been selected under the Quick
menu or the Menu mode, the procedure for changing data will be the
same. Pressing the [CHANGE DATA] key gives access to changing the
selected parameter, following which the underlining in line 4 will flash on
the display. The procedure for changing data depends on whether the
selected parameter represents a numerical data value or a text value.
Changing a data value
If the selected parameter is a text value, the text value is changed by
means of the [+ / -] keys.
The bottom display line will show the value that will be entered (saved)
when acknowledgment is given [OK].
Change of numeric data value
If the selected parameter is represented by a numerical data value, a digit
is first chosen using the [< >] keys.
The selected digit can then be changed infinitely variably using the [+ /
-] keys:
The chosen digit is indicated by the digit flashing. The bottom display line
shows the data value that will be entered (saved) when signing off with
[OK].
MG.04.B8.02 - VLT is a registered Danfoss trademark
3 Programming
FREQUENCY
50.0 Hz
001 LANGUAGE
ENGLISH
FREQUENCY
50.0 Hz
SETUP
1
130 START FREQUENCY
09.0 HZ
FREQUENCY
50.0 Hz
SETUP
1
130 START FREQUENCY
10.0 HZ
3
35