Handbrake Front Cable - MG MG6 Series 2011 Service Manual

Brake System
7. Disconnect multiplug from handbrake warning switch
and remove handbrake warning switch.
Refit
1. Fit handbrake warning switch to handbrake lever.
2. Carefully feed handbrake cable through handbrake lever.
3. Fit handbrake lever to body and tighten bolts to
19–22Nm.
4. Connect handbrake warning lamp multiplug.
5. Fit handbrake cable to handbrake lever and secure with
nut but not fully tighten at this stage.
6. Adjust handbrake.
Handbrake - - - Adjustment Adjustment
Handbrake Handbrake Adjustment
7. Fit centre console.
Console Console Console Assembly Assembly Refit Assembly Refit Refit
Version 2.0

Handbrake Front Cable

Remove
1. Remove centre console.
Console Assembly Assembly Remove Remove
Console Console Assembly Remove
2. Remove handbrake cable adjusting nut, release cable
collect washer.
3. Raise the vehicle on a lift.
4. Remove intermediate exhaust pipe.
Intermediate Intermediate Pipe Intermediate Pipe Remove Pipe
5. Remove bolts securing heat shield to body and remove
heat shield.
6. Release 2 rear handbrake cables from handbrake
compensator.
7. Remove handbrake front cable.
Refit
1. Fit handbrake front cable to body.
2. Connect handbrake cable to compensator.
3. Position centre heat shield, fit and tighten bolts to
19–25Nm.
4. Fit intermediate exhaust pipe.
Intermediate Pipe Intermediate Intermediate Pipe Refit Pipe
5. Lower the vehicle.
6. Feed handbrake cable through handbrake lever, fit and
Park Brake
Remove Remove
Refit Refit
632