Lever-Gearshift Selector Assembly-Automatic - MG MG6 Series 2011 Service Manual

Transmission
through aperture to secure gear selector cable to
neutral start switch. Tighten nut to 14–18Nm.
2. Align cable to fitted position, fit bolts securing gear
selector cable bracket to gearbox and tighten to
40–50Nm.
3. Position cable through body and secure 'C' clip within
the vehicle, ensuring 'O' ring is securely in place.
4. Position exhaust heatshield, fit RH bolt and tighten
to4–6Nm.
5. Fit gear selector cable and bushing to gear selector
assembly.
6. Fit wood trim to centre console.
Wood Trim–Refit Trim–Refit
Wood Wood Trim–Refit
7. Fit air cleaner.
Air Air Air Cleaner–Refit Cleaner–Refit Cleaner–Refit
8. Connect battery earth lead.
Version 2.0
Lever–Gearshift Selector Assembly–Automatic
Remove
1. Remove centre console.
Console Assembly–Remove Assembly–Remove
Console Console Assembly–Remove
2. Release 2 screws and 1 bolt, remove centre console
duct.
3. Disconnect 2 multiplugs.
4. Release clip securing wiring harness to selector
assembly.
5. Release inner cable from selector lever.
6. Remove clip securing outer cable to selector housing
and release cable from gear selector assembly.
7. Remove 4 bolts securing selector assembly to vent and
remove selector assembly.
Refit
1. Position selector housing to body, fit and tighten bolts
to 19–25Nm. Connect inner cable to selector lever
and secure outer cable to selector housing with clip.
2. Position selector housing to vent, fit and tighten bolts
to 9Nm.
3. Connect multiplugs and secure wiring harness to gear
selector assembly.
4. Fit centre console duct and secure with bolt and screws.
5. Fit centre console.
Console Assembly–Refit Assembly–Refit
Console Console Assembly–Refit
Shift Lock Control-AT
350