Mounting Rubbers-Anti Roll Bar-Set - MG MG6 Series 2011 Service Manual

Front Suspension

Mounting Rubbers-Anti Roll Bar-Set

Remove
1. Raise the vehicle on a lift.
2. Remove undertray.
Undertray–Assembly Remove
Undertray–Assembly Undertray–Assembly
3. Remove 4 bolts securing steering rack to subframe.
4. Carefully release steering rack from subframe and tie
aside to access anti-roll bar clamp bolts.
5. Remove 4 bolts securing each anti-roll bar bush clamp
to subframe.
6. Remove clamps and bushes.
Refit
1. Fit bushes to anti roll bar and locate to abutments.
Caution: Anti roll bar bushes have a special coating and
must not be lubricated.
2. Fit clamps.
3. Fit bolts and tighten each bolt in turn to22–28Nm.
4. Check that each bolt is tightened.
Caution: Failure to carry out this procedure can result in
bolts being incorrectly tightened.
5. Release steering rack and align to subframe, fit bolts
and tighten to40–50Nm.
6. Fit undertray.
Version 2.0
Remove
Remove
Undertray–Assembly Undertray–Assembly Refit Undertray–Assembly
7. Lower the vehicle.
Suspension System
Refit Refit
563