Camshaft Drive Belt Cover - Rear Upper - MG MG6 Series 2011 Service Manual

Engine

Camshaft Drive Belt Cover - Rear Upper

Remove
1. Disconnect battery earth lead.
2. Remove camshaft drive belt.
Camshaft Camshaft Camshaft Drive Drive Drive Belt Belt Belt
3. Suitably identify each timing gear to its respective
camshaft.
4. Remove timing gear locking tool T10029.
5. Use T10030to restrain timing gears, remove bolts,
washers and gears from camshafts.
6. Remove bolt securing dipstick support bracket.
7. Remove screw securing drive belt rear upper cover to
coolant pump.
8. Remove bolts securing drive belt rear upper cover to
engine and remove cover.
Version 2.0
Refit
1. Fit drive belt rear upper cover, fit new bolts and tighten
to 8–11Nm.
2. Tighten bolt securing dipstick support bracket to
7–10Nm.
3. Clean gears and camshaft mating faces.
4. Fit timing gears to camshafts ensuring that drive pins are
located in correct slot in gears. Fit bolts and washers
to retain gears.
5. Restrain each gear in turn using tool T10030 and
tighten bolts to 61–68Nm.
6. Align timing gear timing marks using tool T10030.
7. Fit camshaft drive belt.
Camshaft Drive Camshaft Camshaft Drive Belt Drive Belt Belt
8. Connect battery earth lead.
Engine Mechanical-1.8T
94