Charcoal Canister; Purge Control Valve - MG MG6 Series 2011 Service Manual

Engine

Charcoal Canister

Remove
1. Raise the vehicle on a lift.
2. Remove bolt securing canister to body and release
canister.
3. Disconnect air vent pipe.
4. Disconnect purge valve and tank pipes.
5. Remove charcoal canister.
Caution: Always fit plugs to open connections to prevent
contamination.
Refit
1. Ensure all components and mating faces are clean.
2. Connect tank pipe, purge valve pipe and air vent pipe
to canister.
3. Fit canister to body, fit bolt and tighten to 10–15Nm.
4. Lower the vehicle.
Version 2.0
Engine Fuel & Management System

Purge Control Valve

Remove
1. Disconnect battery earth lead.
2. Raise the vehicle on a lift.
3. Disconnect purge control valve multiplug.
Undertray Undertray Undertray - - - assembly assembly Remove. assembly
4. Disconnect purge control valve multiplug.
5. Release clip and disconnect hose from inlet manifold.
6. Release clip and disconnect breather hose from fuel
tank.
7. Remove purge control valve from bracket on cylinder
block.
Refit
1. Connect breather hose to fuel tank.
2. Connect hose to purge control valve.
3. Connect purge valve multiplug.
4. Fit purge control valve to the bracket on cylinder block.
5. Fit undertray.
Undertray - - - assembly assembly Refit.
Undertray Undertray assembly
6. Lower vehicle.
7. Connect battery earth lead.
Remove. Remove.
Refit.
Refit.
324