Steering Wheel - MG MG6 Series 2011 Service Manual

Steering System

Steering Wheel

Remove
1. Remove drivers airbag.
Airbag - - - Steering Steering Sheel
Airbag Airbag Steering
2. Disconnect steering wheel switch multiplugs.
3. Centralise steering wheel with road wheels in straight
ahead position.
4. Restrain steering wheel and loosen bolt securing
steering wheel to column - do not fully remove bolt.
5. Release steering wheel from column.
6. Remove bolt and steering wheel.
7. Attach tape across edge of rotary coupler to retain
correct setting.
8. Remove 4 screws securing horn switch to steering
wheel and remove horn switch.
Version 2.0
Sheel - - - Driver Driver Remove. Remove.
Sheel Driver Remove.
Steering Wheel and Column
9. Remove 4 screws securing LH and RH switch finishers
to steering wheel and remove both finishers.
10. Disconnect horn switch multiplug from steering wheel
switch harness and release harness from cable tie.
11. Disconnect earth lead.
12. Carefully release ribbon cable from steering wheel.
Refit
1. Fit horn switch assembly to steering wheel and secure
with screws.
2. Position ribbon cable and secure to steering wheel.
3. Position harness to steering wheel.
4. Fit LH and RH switch finishers and secure with screws.
5. Connect horn switch multiplug and secure to steering
wheel harness.
6. Remove tape from rotary coupler.
7. Ensure road wheels are in straight ahead position and
fit steering wheel to column.
8. Fit and tighten bolt securing steering wheel to column
to 60–70Nm.
9. Connect horn switch multiplug.
10. Connect steering wheel switch multiplugs.
11. Fit drivers airbag
Airbag - - - Steering Airbag Airbag Steering Wheel Steering Wheel - - - Driver Wheel Driver Refit. Driver Refit. Refit.
540