Table of Contents
Advertisement
Transmission-MT
Lubrication System–Manual Transmission–Top
up
Check & Top Up
1. Raise vehicle on a lift.
2. Clean area around filler plug.
3. Remove filler plug.
4. Fill gearbox through filler plug hole, until oil is level
with the bottom of the hole.
5. Clean filler plug.
6. Fit gearbox filler plug and tighten to 30–40Nm.
7. Lower vehicle.
Version 2.0
Oil Seal–Differential–LH
Remove
1. Remove LH drive shaft.
LH LH LH Shaft
Shaft with
with Both
Both Joints–Remove
Shaft
with
Both
2. Carefully remove and discard differential oil seal, take
care not to damage oil seal recess.
Refit
1. Clean oil seal recess.
2. Using T24010, fit a new differential oil seal.
Caution: Oil seals are waxed and must not be lubricated
prior to fitting.
3. Fit LH drive shaft.
LH LH LH Shaft
Shaft with
Shaft
with Both
with
Both Joints–Refit
Both
4. Top up transmission oil level.
Lubrication
Lubrication System–Drain
Lubrication
System–Drain & & & Refill
System–Drain
Transmission
Joints–Remove
Joints–Remove
Joints–Refit
Joints–Refit
Refill
Refill
417
Advertisement
Table of Contents
