Intake Manifold Gasket - MG MG6 Series 2011 Service Manual

Engine
tool T10015.
Caution: Oil seals are waxed and must not be lubricated
prior to fitting.
12. Fit camshaft cover.
Camshaft Camshaft Camshaft Cover Cover Gasket Cover Gasket Gasket
13. Fit screws securing camshaft drive belt rear upper
cover to cylinder head and coolant pump and tighten
to 8–11Nm.
14. Ensure timing gears are clean and free from oil or
grease.
Caution: If sintered gears have been subjected to
prolonged oil contamination, they must be soaked in
solvent and then thoroughly washed in clean solvent
before refitting. Because of the porous construction of
sintered material, oil impregnated in the gear will emerge
and contaminate a new belt.
15. Fit timing gears to camshafts ensuring that timing marks
are aligned and that drive pins are located in correct
slot in gears.
16. Restrain timing gears using tool T10030.
17. Fit bolts and washers and tighten to 61–68Nm.
18. Ensure timing marks on gears are aligned.
19. Fit timing gear locking tool T10029.
20. Fit camshaft drive belt.
Camshaft Drive Camshaft Camshaft Drive Belt Drive Belt Belt
21. Connect battery earth lead.
Version 2.0

Intake Manifold Gasket

Remove
1. Disconnect battery earth lead.
2. Drain cooling system.
Coolant - - - Drain Coolant Coolant Drain Drain and and and Refill
3. Remove air cleaner.
Air Air Air Cleaner Cleaner Cleaner
4. Disconnect purge valve hose from intake manifold.
5. Disconnect multiplug from electronic controlled
throttle.
6. Disconnect breather hose from intake manifold.
7. Press plastic collar and disconnect brake servo hose
from intake manifold.
8. Remove 3 screws securing spark plug cover and remove
cover.
Engine Mechanical-1.8T
Refill Refill
84