Engine Mounting - Rh - MG MG6 Series 2011 Service Manual

Engine
4. Remove bolts and remove flyingwheel locking tool.
5. Fit ancillary drive belt.
Drive Drive Drive Belt Belt Belt
6. Fit wheel and tighten bolts to 115–130Nm.
7. Remove stand(s) and lower vehicle.
8. Fit starter motor.
Starter Motor Motor
Starter Starter Motor
9. Connect battery earth lead.
Version 2.0
Engine Mechanical-1.8 VCT

Engine Mounting - RH

Remove
1. Disconnect battery earth lead.
2. Support engine on jack.
Caution: To prevent damage to components, cushion the
jack pad with a block of wood or hard rubber.
3. Remove 3 bolts securing PAS reservoir to engine RH
mounting, and position reservoir aside.
4. Remove 3 bolts securing engine RH mounting to engine.
5. Remove 2 bolts securing engine RH mounting to body.
6. Remove engine RH mounting.
Refit
1. Clean mounting mounting and body mating faces.
2. Fit engine RH mounting to engine. Secure 2 bolts
from engine RH mounting to body and tighten to
90–110Nm.
3. Fit 3 bolts from engine RH mounting to engine and
tighten to 90–110Nm.
4. Fit bolts from PAS reservoir to engine RH mounting
and tighten to 7–10Nm.
5. Lower and remove jack.
6. Connect battery earth lead.
190