Sensor - Manifold Absolute Pressure (Map); Sensor - Knock (Ks) - MG MG6 Series 2011 Service Manual

Engine

Sensor - manifold absolute pressure (MAP)

Remove
1. Disconnect battery earth lead.
2. Disconnect MAPsensor multiplug.
3. Remove 2 screws securing MAPsensor to air duct and
remove sensor.
Refit
1. Clean MAPsensor and component mating faces.
2. Fit MAPsensor to air duct and secure with screws to
1.8 - 2.4 Nm.
3. Connect1.8–2.4NmMAP sensor multiplug.
4. Connect battery earth lead.
Version 2.0
Engine Fuel & Management System

Sensor - Knock (KS)

Remove
1. Disconnect battery earth lead.
2. Remove undertray.
Undertray Undertray Undertray - - - assembly assembly assembly . . .
3. Disconnect knock sensor multiplug.
4. Remove bolt securing knock sensor to cylinder block
and remove knock sensor.
Refit
1. Clean component mating faces.
2. Position knock sensor to cylinder block ensuring
harness is correctly routed, fit bolt and tighten to
25Nm
3. Connect multiplug to knock sensor.
4. Fit undertray.
Undertray Undertray - - - assembly. Undertray assembly. assembly.
5. Connect battery earth lead.
320