MG MG6 Series 2011 Service Manual page 136

Engine
from manifold.
Caution: Always fit plugs to open connections to prevent
contamination.
17. Release clip and disconnect purge hose from throttle
housing.
18. Press plastic collar on quick release connector and
disconnect brake servo vacuum hose from intake
manifold.
19. Release clip and disconnect expansion tank hose from
intake manifold.
20. Remove alternator heat shield.
Heat Shield Heat Heat Shield - - - Alternator Shield Alternator Alternator
21. Remove camshaft cover.
Version 2.0
Camshaft Cover Camshaft Camshaft Cover Cover Gasket Gasket Gasket
22. Using sequence shown, progressively loosen cylinder
head bolts 1 to 6; remove bolts and store in fitted order.
23. Remove locking tool T10029from timing gears.
24. Using tool T10030rotate both camshafts clockwise to
gain access to cylinder head bolts 7 and 8.
25. Using sequence shown, progressively loosen cylinder
head bolts 7 to 10; remove bolts and store in fitted
order. Do not rotate crankshaft until cylinder liner
retainer clamps T10018are fitted.
26. Suitably identify each timing gear to its respective
camshaft and using T10030tool to hold timing gears
against rotation, remove 2 bolts and washers retaining
timing gears.
27. Remove timing gears.
28. Remove bolt securing dipstick support bracket.
Engine Mechanical-1.8T
120