MG MG6 Series 2011 Service Manual page 123

Engine Mechanical-1.8T
52. Disconnect pad wear indicator harness multiplug,
release harness from clip.
53. Remove nut and bolt securing lower ball joint to RH
front lower suspension arm.
54. UsingT32020 andT32011 release ball joint from lower
suspension arm.
55. Fit lower arm ball joint protector T32003.
56. Remove 3 bolts securing intermediate shaft bearing
support to engine.
57. Remove nut from LH track rod ball joint.
58. Fit an M10 nut to ball pin, flush with end of pin and
using T38008release ball joint taper.
Version 2.0
59. Remove M10 nut from ball pin.
60. Release clip securing LH brake hose and release brake
hose from support bracket and clip onABS sensor
harness. ReleaseABS sensor harness from support
bracket.
61. Remove nut and bolt securing lower ball to LH lower
suspension arm.
62. Using T32020and T32011, release ball joint from
lower suspension arm.
63. Fit lower arm ball joint protector T32003.
64. UsingT30001 release LH inner drive shaft joint from
transmission.
65. With assistance, pull front hubs outwards and release
drive shaft and intermediate shaft from transmission.
Keep both shafts square to avoid damage to oil seals
in transmission.
66. Remove and discard circlip from LH drive shaft inner
joint.
Engine
107