Switch Pack Assembly - Driver Seat; Cover - Driver Cushion - Front - MG MG6 Series 2011 Service Manual

Interior Fitting

Switch pack assembly - driver seat

Remove
1. Remove front seat.
Side Board Board Outer Outer - - - Power
Side Side Board Outer
2. Remove screw securing valance to seat.
3. Release 2 clips securing valance to seat and release
valance.
4. Remove 3 screws securing switch pack to valance and
release switch pack.
5. Disconnect switch pack multiplug and remove switch
pack.
Refit
1. Fit switch pack to valance and secure with screws.
2. Connect switch pack multiplug.
3. Secure valance to seat with clips and screw.
4. Fit front seat side board.
Side Board Board Outer Outer - - - Power
Side Side Board Outer
Version 2.0
Power Seat Seat Remove Remove
Power Seat Remove
Power Seat Seat Refit Refit
Power Seat Refit

Cover - driver cushion - front

Remove
1. Fully raise seat cushion.
2. Remove outer valance.
Side Side Board Side Board Outer Board Outer - - - Power Outer
3. Remove screw securing inner valance to seat.
4. Release inner valance from clip and remove valance.
5. Release 3 clips securing squab cover to cushion frame.
6. Disconnect squab harness multiplug.
7. Remove 4 bolts securing squab to cushion frame and
remove cushion.
Seats
Power Seat Power Seat Remove Seat Remove Remove
678