Headlamps - Dip Beam, High Beam; Headlamp Assembly - MG MG6 Series 2011 Service Manual

Lighting Systems

Headlamps - Dip Beam, High Beam

Check
1. Position beam setting equipment to headlamp.
2. Switch headlamps on and note main beam settings.
Beam must be 1.0% below the horizontal and parallel
to the vehicle centre line.
3. Adjust headlamp if required.
4. Switch off headlamps and remove beam setting
equipment.
Adjust
1. Turn inner adjuster as necessary to get correct
horizontal beam setting for dip beam.
2. Turn outer adjuster as necessary to correct vertical
beam setting dip beam.
3. Turn inner adjuster as necessary to get correct
horizontal beam setting for high beam.
4. Turn outer adjuster as necessary to correct vertical
beam setting high beam.
Version 2.0

Headlamp Assembly

Remove
1. Disconnect battery earth lead.
2. Remove front bumper.
Bumper Bumper Assembly Bumper Assembly - - - Front-Remove. Assembly
3. Remove 4 bolts securing headlamp to body.
4. Disconnect multiplug from headlamp assembly.
5. Remove headlamp assembly.
Refit
1. Position headlamp assembly to body.
2. Align headlamp assembly, fit bolts and tighten.
3. Connect multiplug to headlamp.
4. Fit front bumper.
Bumper Bumper assembly Bumper assembly assembly - - - front-Refit.
5. Connect battery earth lead.
6. Check headlamp alignment.
Headlamps - - - dip dip beam, beam, high
Headlamps Headlamps dip beam,
Lamps
Front-Remove. Front-Remove.
front-Refit. front-Refit.
high beam-Refit. beam-Refit.
high beam-Refit.
760