Table of Contents
Advertisement
Transmission
8. Position shift and selector shaft through control
assembly.
9. Fit 5th/Reverse gear return spring, interlock assembly,
gear shift arm guide, reverse lock selector assembly,
1st/2nd gear return spring and return spring thrust
plate in the correct sequence.
Caution: Ensure that the above components are fitted in
the correct sequence on the shaft.
10. Fit gear shift lever to shift and selector shaft.
11. Fit assembled parts into housing and tighten bolts
securing interlock assembly to30–40Nm.
12. Position nylon block and fit gear selector lever.
13. Fit manual transmission assembly.
Manual Transmission
Transmission Assembly–Refit
Manual
Manual
Transmission
Version 2.0
Assembly–Refit
Assembly–Refit
Fittings and Release Mechanism
Remove
1. Remove slave cylinder bracket.
2. Remove cable support bracket.
3. Remove reverse lamp switch.
4. Remove 3 self-locking dowels assembly.
5. Remove oil filler and drain plugs.
6. Remove bolt securing interlock assembly.
7. Remove control assembly.
Transmission-MT
428
Advertisement
Table of Contents
