Outer Ball Joint Boot-Front Lower Arm - MG MG6 Series 2011 Service Manual

Suspension System
5. Remove lower arm outer ball joint protectorT32003
and inspect ball joint boot for damage.Ensure lower
arm outer ball joint is fully engaged in swivel hub and
bolt is located in ball joint groove.
6. Connect lower arm outer ball joint to hub, fit nut and
bolt and tighten to 40–50Nm.
7. Ensure lower arm outer ball joint is fully engaged in
swivel hub and bolt is located in ball joint groove.
Caution: Nuts and bolts must be tightened with weight of
vehicle on suspension.
8. Fit road wheels and tighten bolts to 115–130Nm.
9. Fit undertray.
Undertray-Asembly Refit
Undertray-Asembly Undertray-Asembly
10. Check wheel alignment.
Wheel Wheel Wheel Alignment Alignment Refit Alignment Refit Refit
Version 2.0
Refit
Refit

Outer Ball Joint Boot-Front Lower Arm

Remove
Caution: This ball joint boot kit should only be used if the
boot is damaged during a service. It must not be used if
the vehicle has been driven with a damaged boot.
1. Remove front lower arm.
Lower Lower Arm-Front Lower Arm-Front Arm-Front Remove Remove Remove
2. Remove and discard 2 spring rings securing ball joint
boot to ball joint.
3. Remove and discard ball joint boot.
Refit
1. Clean ball joint.
2. Apply grease from ball joint boot kit.
3. Fit top spring ring to new boot.
4. Fit boot to ball joint and engage lower part of boot to
ball joint groove.
5. Fit special toolT32023 over new boot.
Front Suspension
554