Injectors - MG MG6 Series 2011 Service Manual

Engine Fuel & Management System
9. Release spring clips securing injectors to fuel rail and
remove injectors.
10. Remove and discard 2 O-rings from each injector.
11. Fit protective caps to each end of injectors.
Refit
1. Remove protective caps from injectors.
2. Clean injectors, fuel rail and inlet manifold groove.
3. Lubricate new O-rings and fit to injectors.
4. Fit injectors to fuel rail.
5. Secure injectors to fuel rail with spring clips.
6. Position fuel rail in inlet manifold and connect injector
multiplugs.
7. Push each injector into inlet manifold.
8. Fit 2 bolts securing fuel rail to inlet manifold and tighten
to 9Nm
9. Connect fuel feed hose to fuel rail.
10. Fit engine oil dipstick.
11. Connect battery earth lead.
12. Check fuel rail for leakage.
Fuel Fuel system Fuel system－ － － pressure system pressure release pressure
Version 2.0
release release

Injectors

Remove
1. Remove fuel rail.
Fuel rail rail
Fuel Fuel rail
Refit
1. Fit fuel rail.
Fuel Fuel rail. Fuel rail. rail.
Engine
323