Engine Mounting Lower Tie Rod; 1.8Vct Camshaft Front Oil Seal - Exhaust - MG MG6 Series 2011 Service Manual

Engine Mechanical-1.8 VCT

Engine Mounting Lower Tie Rod

Remove
1. Remove underbelly panel.
Undertray - - - Assembly Assembly
Undertray Undertray Assembly
2. Remove 2 bolts securing engine mounting lower tie rod
to engine mounting lower tie rod bracket and subframe.
3. Remove engine mounting lower tie rod from mounting
brackets.
Refit
1. Position engine mounting lower tie rod to mounting
brackets.
2. Fit bolts securing engine mounting lower tie rod and
tighten to 90–110Nm.
3. Fit underbelly panel.
Undertray Undertray Undertray - - - Assembly Assembly Assembly
Version 2.0

1.8VCT Camshaft Front Oil Seal - Exhaust

Remove
1. Disconnect battery earth lead.
2. Remove drive belt upper rear cover.
Camshaft Camshaft Drive Camshaft Drive Drive Belt Belt Cover Belt
3. Remove camshaft oil seal using T10022andT10023.
4. Remove and discard seal.
5. Remove bolt from camshaft.
Refit
1. Clean camshaft seal locations and running surfaces.
2. Fit T10013to end of camshaft to protect seal.
3. Noting that this oil seal is coloured black, fit new
camshaft oil seal using toolT10015.
Caution: Oil seals are waxed and must not be lubricated
prior to fitting.
4. Fit drive belt upper rear cover.
Camshaft Camshaft Camshaft Drive Drive Belt Drive Belt Cover Belt
5. Connect battery earth lead.
Engine
Cover - - - Rear Cover Rear Upper. Rear Upper. Upper.
Cover - - - Rear Cover Rear Upper Rear Upper Upper
191